yield stress


Also found in: Medical, Encyclopedia, Wikipedia.
Related to yield stress: ultimate stress

yield stress

n
(General Physics) the stress level at which a metal or other material ceases to behave elastically. The stress divided by the strain is no longer constant. The point at which this occurs is known as the yield point. Compare proof stress
Translations
tensione di snervamento
Mentioned in ?
References in periodicals archive ?
The modulus of elasticity and the compressive yield stress were measured and estimated as 181 GPa and 500 MPa, respectively, based on the data obtained from an extensometer attached to the two plates that were used to compress the specimens.
Figure 5a and b provides more detail to show that annealing the samples at 150[degrees]C increased the Young's modulus (E) less than 50% and the yield stress ([[sigma].
This paper obtains from the magnetorheological effect of magnetic fluid, the yield stress formula of magnetic liquid was deduced, based on the the yield stress formula of magnetic liquid, The mechanism of magnetic fluid seal is analyzed, the pressure formula of magnetic fluid seal is Concluded, and then the experimental investigation was conducted.
This study aims to characterize the grain size distribution (GSD), soil consistency (Atterberg Limits) and the influence of moisture content on the yield stress of rainfall-induced landslide prone areas along the route corridor.
Called iNano, the nanoindenter can test materials both quasi-statically and dynamically, and gives users a range of information about their specimens including elastic modulus, yield stress, work hardening exponents, creep stress exponents, fatigue properties and storage and loss modulus.
Therefore, we should not expect to be able to use the material above the yield stress for even a very short duration.
Tables organize the data on each specific commercial product, listing tensile modulus, yield stress, yield at strain, stress at break, charpy notched impact, relative permittivity, dissipation factor, and water absorption.
Unless the gravitational shear stress exceeds the yield stress, no sagging will occur.
2 can perform a wide variety of tests, including viscoelastic modulus, yield stress, viscosity vs.
The RST Rheometers are unique because they operate in both controlled stress and controlled rate modes and can perform all of the following tests: viscoelastic modulus, yield stress, viscosity vs.
Both yield stress and viscosity (apparent or plastic) are strongly dependent on the particle characteristics of the powders employed in preparing a blended cement/ fly ash paste with a constant volume fraction of water.