The tangential deviatoric stress is the force along the tangent line of the residual oil film, and the higher tangential deviatoric stress results in a larger
angular deformation. The trend of tangential deviatoric stress in Figure 8 shows that there is a dividing point between 1/4 and 1/2 lengths along the flowing direction, and the tangential deviatoric stress is negative before the point and positive behind the point.
The
angular deformation velocity and acceleration curves of point [P.sub.E] of a singular material and laminated beams are illustrated in Figures 8 and 9, respectively.
From here the maximum width the zone of sliding a is determined depending on the pressing pressure [p.sub.0] and the amount of the
angular deformation bend of laminated element for a specific material, whose parameters are given values of E, G, f and dimensions of the steel sheets (H, h, 3):
More specifically torsional loading, axial deformation,
angular deformation, centrifugal force caused by rotation and finally a combination of all of these conditions was done, see Fig.
A small (5-7 degrees)
angular deformation can be eliminated by moving the rod fragments towards the top corner of deformation.
Similarly, the
angular deformation of the edge at B has to be 0 because of the symmetry of the problem.
The mixture of WCS-0.35% xanthan gum had a higher
angular deformation than those mixtures with 0.5%, 0.7% and 1% xanthan gum.
Due to
angular deformation of the shaft electrical resistance of gages is changed and picked up by the acquisition system in the form of electrical potential change.
([cm.sup.-1]) Absorption Assignment EPDM 2,968, 2,722 -CH Stretching vibration 1,735 C=C Stretching vibration 1,460 C[H.sub.2]
Angular deformation 1,376 C[H.sub.3]
Angular deformation 720 C[H.sub.2]
Angular deformation EPDM-g-MAH 2,967, 2,359 -CH Stretching vibration 2,021 C-O Assymmetric stretching 1,715 C=O Symmetric stretching 1,448 C[H.sub.2]
Angular deformation 1,375 C[H.sub.3]
Angular deformationIt is considered as being deformation a quantity of type of: elastic deformation, plastic deformation or displacement; linear deformation or
angular deformation. Let [bar.U] represent one deformation or a resultant of more deformations.
In the case of an
angular deformation, these components have to be obtained for at least two points (see fig.