polar coordinate system

Also found in: Encyclopedia, Wikipedia.

polar coordinate system

A system of coordinates in which the location of a point is determined by its distance from a fixed point at the center of the coordinate space (called the pole), and by the measurement of the angle formed by a fixed line (the polar axis, corresponding to the x-axis in Cartesian coordinates) and a line from the pole through the given point. The polar coordinates of a point are given as (r, θ), where r is the distance of the point from the pole, and θ is the measure of the angle.
The American Heritage® Student Science Dictionary, Second Edition. Copyright © 2014 by Houghton Mifflin Harcourt Publishing Company. Published by Houghton Mifflin Harcourt Publishing Company. All rights reserved.
Mentioned in
References in periodicals archive
Alternatively, a polar coordinate system can be used for targeting, with the needle angled slightly upwards as opposed to perpendicular in the Cartesian coordinate system.
Similarly, in Table II, there are relative changes of parameters of the considered indices when SE is realized in the polar coordinate system. The mentioned changes of the parameters of the considered indices characterizing properties of PSSE are calculated using formula: [DELTA][p.sub.X] = 100([p.sub.X,S] - [p.sub.X,S-])/ [p.sub.X,S-], where [p.sub.X,S], [p.sub.X,S-] are parameters of index X, when SE is performed for PS with or without PhS, respectively.
* polar coordinate system [tau], [theta] in a two-dimensional space);
Polar coordinate transformation is similar to Cartesian coordinate transformation, it firstly establishes the polar coordinate system with the center point as the midpoint and the direction of the center point as the positive direction, then divides the fingerprint image into many segments, and each segment is divided into many small blocks.
[18], as the original data is in the polar coordinate system, an interpolation method was utilized to transform the polar coordinate system into the three-dimensional Cartesian coordinate system.
Bear [1] proved that if r = [K.sub.q.sup.1/2] or r = [K.sub.j.sup.-1/2] in the polar coordinate system, mapping can form an ellipse (under the condition of three-dimensional ellipsoid), where r represents radius vector, [K.sub.q] represents permeability coefficient in the direction of the flow line, and [K.sub.j] represents permeability coefficient in the direction of the hydraulic gradient.
Then we turn to the polar coordinate system such that [x.sup.*.sub.[phi]] = 0 (Figure 3) and we assume that values of all angles satisfy -[pi] < [a.sup.i.sub.[phi]] [less than or equal to] [pi] (the case [a.sup.i.sub.[phi]] = 0 is excluded since [x.sup.*.sub.[phi]] [not equal to] [a.sup.i.sub.[phi]]).
From the periodicity of limit cycle and the property of polar coordinate system, we know that the conclusion of the lemma is true.
This block treats [[??].sub.pi,l(n)] as amplitude variation [alpha] and phase shift [DELTA][theta] in a polar coordinate system in order to enable microvariations to be easily calculated.
The resulting coordinate values can be stored in a table and drawn in the plane equipped with the polar coordinate system. GeoGebra is a very convenient tool with which to do so.
The radius e of the trajectory of centre [O.sub.2] of roundness measure and polar angle [alpha] in polar coordinate system are described by the equations
Copyright © 2003-2025 Farlex, Inc Disclaimer
All content on this website, including dictionary, thesaurus, literature, geography, and other reference data is for informational purposes only. This information should not be considered complete, up to date, and is not intended to be used in place of a visit, consultation, or advice of a legal, medical, or any other professional.