Parting is the design of the injection mould for the part of the most important, it is parting surface will contain the volume of the mold cavity block
separated into a dynamic model of the core and cavity model, the parting surface is dynamic model of the core and the contact surface of the cavity model.
He also spotted a pre-cast concrete cavity block
which had been removed from a little hut which housed a small electric water pump.
It is believed she has battered over the head with a slate stone and cavity block
, both of which were lying near her body.
Mrs Toscan du Plantier's body was found so badly beaten by a slate stone or a cavity block
, both of which were lying near her body, that it took some time to formally identify her.
A breed of drinker with a wallet thicker than a cavity block
who doesn't mind coughing up for the simple pleasures in life.
One such case involved a mold cavity block
that cracked after only a short time in use (figure 2).
c) Never let the head of the bushing seat directly against the back of a cavity block
, runner bar, or any other mold insert, unless the insert can be sufficiently retained with heels and / or multiple large screws.
construction will include cavity block
to ground level with sandwich panel cladding to upper level with sandwich panel roof all supported by steel frame structure.
between the deceased's body and the wire fence and within nine inches of her left hand was a nine-inch cavity block
0040" wide x 10" long in a cavity block
that's 12" x 12" and 2" thick.
Despite a robust mold design, quality steel, proper machining, and correct heat treating, the result of excessive tonnage was that the cavity block
separated in two locations.
Prof Harbison said that a cavity block
at the scene and a large stone could have been used during the attack.