countersunk


Also found in: Thesaurus, Acronyms, Encyclopedia.

coun·ter·sunk

 (koun′tər-sŭngk′)
v.
Past tense and past participle of countersink.

countersunk

(ˈkaʊntəˌsʌŋk)
adj
driven or sunk into an enlarged hole
Translations

countersunk

[ˈkaʊntəsʌŋk] ADJ [screw] → encastrado
References in classic literature ?
And if at such times you should think that you really perceived drops of moisture in the spout, how do you know that they are not merely condensed from its vapor; or how do you know that they are not those identical drops superficially lodged in the spout-hole fissure, which is countersunk into the summit of the whale's head?
As the door had slipped aside I had noted its great thickness, fully twenty feet, and as it reached its place once more after closing behind us, great cylinders of steel had dropped from the ceiling behind it and fitted their lower ends into apertures countersunk in the floor.
Countersunk lag screws are visible at top and bottom
Photo: Secure frame to the base with woodscrews that run through predrilled countersunk holes and into the plywood bottom.
The CFV may be mounted with either countersunk head or hex head screws - it features four detent positions of -90[degrees], 0[degrees], +70[degrees] and +115[degrees], all detent positions providing a resistant torque of 3 Nm which is the torque required to free the detent device - and is tested to 20,000 operations.
You can later fill over the countersunk screws with wood filler and, once that's dry, sand smooth.
After wrapping the front and sides of the plywood in a piece of felt, I slipped it into the rack flush with the front edge, fastened it with finishing nails countersunk in the sides of the rack, and attached the pulls through the drilled holes.
The main middle section is a transparent tube, comprising 12mm toughened flush glass skin held using countersunk fixings and silicon sealant between glass sheets.
Greg Masterson, spokesman for Buy American said the site recently added a larger selection of neodynium disc, block and sphere magnets in flat, round, cube, rectangular and square shapes as well as earth magnet, countersunk, counterbored, plastic and rubber coated magnets for weatherproofing.
Drill countersunk holes through all the marked points on the tops of the eight boards and sand off pencil marks.
Tenders are invited for Stainless Steel Countersunk Screw For Flake Chip Board 4X25 To Is: 6760-72, To Is:1367 Part-14 1984 Gr A2-70