magnetic flux density


Also found in: Thesaurus, Medical, Encyclopedia, Wikipedia.
Related to magnetic flux density: magnetic field strength, magnetic field intensity

magnetic flux density

n. Symbol B
The amount of magnetic flux through a unit area taken perpendicular to the direction of the magnetic flux. Also called magnetic induction.

magnetic flux density

n
(General Physics) a measure of the strength of a magnetic field at a given point, expressed by the force per unit length on a conductor carrying unit current at that point. Symbol: B
ThesaurusAntonymsRelated WordsSynonymsLegend:
Noun1.magnetic flux density - the amount of magnetic flux in a unit area perpendicular to the direction of magnetic flowmagnetic flux density - the amount of magnetic flux in a unit area perpendicular to the direction of magnetic flow
field intensity, field strength - the vector sum of all the forces exerted by an electrical or magnetic field (on a unit mass or unit charge or unit magnetic pole) at a given point in the field
References in periodicals archive ?
Moreover, when the currents in different power lines change, not only the level of the total MF generated by several TL changes, but also the space-time electromagnetic field characteristics (STC) of the MF due to the relative redistribution of the vertical and horizontal components of the magnetic flux density vector created by different TL.
11 show that the magnetic flux density at the place where section 1 makes a contact with the platform is 0.
The magnetic flux density (B) at the center of the column coils is measured with magnetic sensor and B was adjusted by varying the coil current.
No-load magnetic flux density distribution over magnet pole and iron pole pitch of the [V.
Fast response to power-on and changes in magnetic flux density and feature a reverse blocking diode, Zener clamps on the supply and output, and output over-current limiting to provide device protection and high ESD immunity
Figure (11) shows the magnetic flux density distribution for two broken rotor bars as a sample for show the effect of broken bars on the flux distribution.
They offer a fast response to power-on and changes in magnetic flux density and feature a reverse blocking diode, Zener clamps on the supply and output, and output over-current limiting to provide device protection and high ESD immunity.
So this part concentrates on current density distribution and magnetic flux density distribution graphs at different gap distances and the voltage frequency is fixed at 400 Hz.
In all the 2D FE models, the radial component of the magnetic flux density is neglected.
The types of matrix material, concentration of magnetizable particles, and magnetic flux density can influence the modulus change of MRE [4, 5],
From sources we know, that the necessary results can be considered as the level of magnetic flux density of more than 1 Tl [2].
When the magnetic flux density (B) perpendicular to the package is larger than operate point (Bop), the output will be turned on (pulled low) and held until B is lower than release point (Brp).