The

arithmetic average value is 17.38 cm for initial testing and 22.71 cm for final testing.

There was observed a similar trend: the average boiling point found for a cut by the thermogravimetric method was always lower than the one calculated from ASTM D86 distillation data (as an

arithmetic average of the initial and final temperatures of the cut).

This same estimation method was followed as in the study of Temple-Bird.12 In order to calculate the ratio between the total expenditures of medical device spare parts and the total acquisition cost of medical devices, considering the obtained acquisition costs of technological development level and the spare parts expenditure ratios according to the technological development level which was taken as a reference, the normalized weighted

arithmetic average method is applied.

where: [mathematical expression not reproducible]--average percentage damage of the surface of the top fracture face (rock), corresponding to

arithmetic average of the obtained values for individually specified areas (%); [PDW.sub.e]--average percentage damage of the surface of the bottom fracture face (rock), corresponding to

arithmetic average of the obtained values for individually specified areas (%)

It is obvious from table 5 above that the

arithmetic average of change management variable is equal 3.38 and the calculated t-value equal 12.60 and the Sig.

In addition, at the end of the non-disclosure period, the firm must publish its tax details retroactively "in the form of an

arithmetic average" to cover that period when they did enjoy immunity from providing details.

The agricultural knowledge level of farmers and its application to coffee crop production: The answers from the respondents to each question about their knowledge level are shown in Table 2 in descending order, according to the

arithmetic average for each question.

The "overall" [[sigma].sub.x] is equal to the

arithmetic average [[sigma].sub.x] over Side 1.

In Fitch's analysis on energy-related borrowing bases the

arithmetic average of hedge volume in place on 2015's prices as a fraction of thirdquarter 2014 production for 15 EandP producers was 61%.

As the design scheme "bicycle configuration" was used, in which the speed of the front and rear wheels were equal to the

arithmetic average speeds of the front and rear wheels, respectively:

Assuming a constant heat flux at the bore hole wall implies p = 1, and the p linear average becomes the

arithmetic average. However, Marcotte and Pasquier (2008) showed with numerical simulations that a constant heat flux at the borehole wall rarely occurs and suggested using p [right arrow] -1 to take into account the change of heat injection rate along the depth of the GHE.

Also known as the "

arithmetic average," the mean is derived simply by totaling the data measurements and dividing this sum by the number of observations.