Acquire Fully-Loaded Research Reports https://www.mrrse.com/automotive-refinish-coatings-market-2018-2026 Manufacturers are adopting high molar volume
technology for formulating effect pigment concentrates and solventborne solid.
A simple comparative study between the effect of doping glasses with CuO and/or TeO2 is argued by characterization some of their chemical and physical properties such as; density, molar volume
, electrical conductivity, UV optical properties and chemical durability.
The composition, salinity and molar volume
of type I inclusions were modeled on the ICE program (Bakker, 1997; Bakker & Brown, 2003), using the state equation of Peng & Robinson (1976).
where, [v.sub.1], [v.sub.2], [v.sub.3] represent the molar volume
of pure nonsolvent, solvent, and polymer, respectively.
The molar volume
was then calculated from the density measurement results.
where V = M/[rho] is the molar volume
of the liquid, M is its molar mass, and [rho] is its density.
Taking into account the normal atmospheric conditions to the EE of the conductor, the following basic characteristics for the initial air can be used : the air pressure is [P.sub.1] [approximately equal to] 1.013 x [10.sup.5] Pa; the air temperature was equal to [T.sub.1] [approximately equal to] 273.15 K; the molar volume
of air is [V.sub.M1] [approximately equal to] 22.41 x [10.sup.-3] [m.sup.3]/mol.
The Poynting correction is rigorously related to an isothermal integral of the molar volume
from [p.sup.sat] to p:
For the physical properties of prepared glass samples, density measurement is done at room temperature by using distilled water as the immersion liquid while molar volume
values are calculated from the density results.
The thermodynamic property, partial molar volume
of transfer at infinite dilution ([[DELTA].sub.trs][V.sup.0.sub.[phi]]) of sodium saccharin from water to aqueous fructose solutions was calculated by the use of the following equation .
where [E.sub.coh] (J/mol) is cohesive energy and V ([cm.sup.3]/mol) is molar volume
of each repeat unit of the polymer.