Section Line


Also found in: Encyclopedia, Wikipedia.

Section Line

The imaginary line forming the boundary along one side of a land section. County roads are often routed along section lines.
Mentioned in ?
References in classic literature ?
Grandfather had explained to Ambrosch that some day, when the country was put under fence and the roads were confined to section lines, two roads would cross exactly on that corner.
42 Feet West of the Northeast Corner of Section 18: Thence South and Parallel With the East Section Line 625.
Topstitch the upper sleeve sections so the quilting lines are vertical, pivoting at the section line and spacing the lines 1/4" apart.
Line trees were not located with respect to quarter section corner, but with respect to the section line.
The section is constructed to show the structural variation along trend where the section line cut across different structures exposed at surface as compared to section AA/ and BB/.
303,255,658 135 Section Line Road, 3rd Floor, Hot Springs 71913 52.
Mick Rock was the man in charge of route marking and his choice of section line was just about right for all three classes.
Back to the section line the average values of experimental group at initial testing are 13.
Place the surface geological boundaries along the profile and cross section line along with dip lines, at the appropriate angle, where available from the map.
At the same time, they form a reinhabited heap of debris that rises, quite literally in the accompanying images, above the section line drawn by the waters across the city.
3455, Fall Creek Trail, from the junction of Forest Service Road 18/1821 to Bedrock Campground; the north/south section line of section 27, from Forest Service Road 18 to the corner of sections 26, 27, 34 and 35; from the corner of sections 26, 27, 34 and 35 to Forest Service Road 1821; from where the southern section line of section 27 meets Forest Service Road 1821, proceeding along Forest Service Road 1821 to the junction of Forest Service Road 18.
LTire gets the mold surface information either by digitizing or by loading the profile cross section line (from lathe data).

Full browser ?