The tangential deviatoric stress is the force along the tangent line of the residual oil film, and the higher tangential deviatoric stress results in a larger

angular deformation. The trend of tangential deviatoric stress in Figure 8 shows that there is a dividing point between 1/4 and 1/2 lengths along the flowing direction, and the tangential deviatoric stress is negative before the point and positive behind the point.

The

angular deformation velocity and acceleration curves of point [P.sub.E] of a singular material and laminated beams are illustrated in Figures 8 and 9, respectively.

From here the maximum width the zone of sliding a is determined depending on the pressing pressure [p.sub.0] and the amount of the

angular deformation bend of laminated element for a specific material, whose parameters are given values of E, G, f and dimensions of the steel sheets (H, h, 3):

The drive torque from the motor causes not only the axial and

angular deformation of the screw but also the contact deformation of the balls, the screw, and the nut, according to the Hertzian contact theory.

More specifically torsional loading, axial deformation,

angular deformation, centrifugal force caused by rotation and finally a combination of all of these conditions was done, see Fig.

A small (5-7 degrees)

angular deformation can be eliminated by moving the rod fragments towards the top corner of deformation.

Similarly, the

angular deformation of the edge at B has to be 0 because of the symmetry of the problem.

The mixture of WCS-0.35% xanthan gum had a higher

angular deformation than those mixtures with 0.5%, 0.7% and 1% xanthan gum.

Due to

angular deformation of the shaft electrical resistance of gages is changed and picked up by the acquisition system in the form of electrical potential change.

([cm.sup.-1]) Absorption Assignment EPDM 2,968, 2,722 -CH Stretching vibration 1,735 C=C Stretching vibration 1,460 C[H.sub.2]

Angular deformation 1,376 C[H.sub.3]

Angular deformation 720 C[H.sub.2]

Angular deformation EPDM-g-MAH 2,967, 2,359 -CH Stretching vibration 2,021 C-O Assymmetric stretching 1,715 C=O Symmetric stretching 1,448 C[H.sub.2]

Angular deformation 1,375 C[H.sub.3]

Angular deformationIt is considered as being deformation a quantity of type of: elastic deformation, plastic deformation or displacement; linear deformation or

angular deformation. Let [bar.U] represent one deformation or a resultant of more deformations.

In the case of an

angular deformation, these components have to be obtained for at least two points (see fig.