evaporation pressure

evaporation pressure

American Heritage® Dictionary of the English Language, Fifth Edition. Copyright © 2016 by Houghton Mifflin Harcourt Publishing Company. Published by Houghton Mifflin Harcourt Publishing Company. All rights reserved.
Mentioned in ?
References in periodicals archive ?
It also talks about other requirements such as colour, evaporation pressure and corrosion rate of copper.'
It also talks about other requirements such as colour, evaporation pressure and the corrosion rate of copper, where applicable.
Expansion valve V-1 is adopted to lower evaporation pressure and control refrigeration mass flow rate (2-3).
Ethanol was selected as the working fluid because of its low evaporation pressure, allowing for lighter and lower cost system components [3].
Due to the lower refrigerating capacity of the modified system compressor, the thermal loads and temperature differences in condenser and evaporator decreases, increasing evaporation pressure and efficiency.
Another indicator of improved refrigerant flow distribution is an increase in evaporation pressure. Typically, evaporation temperature (pressure) will increase as refrigerant is more uniformly distributed because the heat exchanger area is used more effectively.
where [P.sub.v] is the real evaporation pressure of gas, Pa; [P.sup.0.sub.v] is the critical evaporation pressure, Pa; f is the disturbance factor.
The main driving force for evaporation is the difference between the evaporation pressure (saturation pressure) and surrounding pressure.
The units incorporate a variable refrigerant capacity (VRC) system to maintain constant evaporation pressure to accommodate variable demand for refrigeration power or refrigerant flow.
Ayub (2003) also proposed to evaluate evaporation pressure drop using the following correlation for Fanning friction factor:
They also give the details of the chemical and physical requirements of gasoline such as octane limits and limits for the content of heavy metals such as lead, manganese, sulphur, iron, etc., as well as other requirements such as colour, evaporation pressure and the corrosion ratio of copper.
When OPR settings were set to nominal, the evaporation pressure increased, and resulted evaporation pressure at initial stage of pull-down was about 6 bar.