iron mold

Also found in: Thesaurus.
ThesaurusAntonymsRelated WordsSynonymsLegend:
Noun1.Iron mold - a spot caused the staining with rust or inkiron mold - a spot caused the staining with rust or ink
discoloration, discolouration, stain - a soiled or discolored appearance; "the wine left a dark stain"
Based on WordNet 3.0, Farlex clipart collection. © 2003-2012 Princeton University, Farlex Inc.
References in periodicals archive ?
The global glass mold market was valued at US$ 802.5 million in 2018, according to Glass Mold Market Report, by Mold Type (Alloy Cast Iron Mold, Ordinary Cast Iron Mold, and Others), by End-use Industry (Chemical, Food & Beverage, Healthcare, and Others), and by Region (North America, South America, Asia Pacific, Europe, and Middle East & Africa) published by Coherent Market Insights.
Hand-blown within an iron mold, the vessel is entirely repolished before its hollow underside gets frosted.
In this case, a passivated iron mold (insert) was prepared.
M2 PRESSWIRE-August 20, 2019-: Global Alloy Cast Iron Mold market is growing at a CAGR of 3.86% and expected to reach USD 4.866 Billion by 2024 from USD 3.877 Billion in 2018
In a factory that manufactures stone blocks, Hasan Salman, 60, picks up mud and places it in an iron mold to form a block of stone.
A simple H-13 tool steel mold typically produces 70,000 castings, while an iron mold produces 40,000 castings, dependent on size of the mold and complexity.
The peak of the Washington Monument in Washington, D.C., is a 100-oz aluminum pyramid cast in an iron mold. Designed to withstand the elements, keep from discoloring the marble monument it capped and conduct electricity, the pyramid was the largest piece of aluminum of its day.
One method to extend iron mold life is the use of thermal spray welding.
For the spacer component, Robinson Foundry melted 319 aluminum in an R&D crucible furnace previously used for lost foam and cast it on one of its existing iron mold lines.
Background--Beyond the necessity of protecting the iron mold from the aggressive attack of molten aluminum, mold coatings also provide casting surface finish and insulating properties that can aid directional solidification of the casting.
The metal composition was 1.7% iron (Fe), 0.55% Si and the balance aluminum, and a cast iron mold was used for the pour.
A jobbing foundry using a particular mold for only a week at a time, and then cleaning it and putting it into storage, may select a low cost, gray iron mold. An automotive foundry, meanwhile, may use their molds for several weeks at a time, clean them and immediately put them back on, and likely require a higher hardness and wear-resistant material.