The transfer function of the approximated fractional Butterworth
low-pass filter of order (1 + [beta]) is given by [20]
The amplified signals are distorted by the presence of muscle artifacts and power line interference; thus, these noises are removed using filter stages 1 and 2 Within this research, a
low-pass filter with a cutoff frequency of 33HZ was used to remove muscle artifacts, and a twin-T notch filter with a cutoff frequency of 60HZ was utilized to eliminate power line interference.
To reduce the noise, a 10 Hz
low-pass filter is designed at each detector channel before the signal is digitized and sampled into the memory.
To isolate the desired signal on the background of periodical and non-interference must have a strictly sinusoidal function switching and
low-pass filter or integrator.
The cut-off frequency of the R-C
low-pass filter is chosen to be same as 800 kHz.
CTS Corporation (NYSE:CTS) disclosed on Thursday that it has launched the RLF (Rooftop
Low-pass Filter) family of products to offer compact, high performance
low-pass filters (LPFs) used in small-cell base stations or other radio frequency (RF) wireless infrastructure applications.
The fractional-order
low-pass filter presented in this paper has been proposed using operational transconductance amplifiers (OTAs), adjustable current amplifiers (ACAs) and fully-differential current follower (FD-CF).
KISTLER INSTRUMENTS says its new type 4503B dual range torque sensor has a wide measurement range of 0.2 to 5,000 Nm, high resolution rotational speed/angle measurement and high speed ranges of up to 50,000 rpm and for highly dynamic measurements the cut-off frequency of 10 kHz may be user customised by an integrated, digital,
low-pass filter and the second measurement range can be flexibly scaled up to 1:10 or 1:5 of the rated torque.
Sanchez-Sinencio, "A 60-dB dynamic-range CMOS sixth-order 2.4-Hz
low-pass filter for medical applications," IEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, vol.
Kim et al., "Modeling of a photonic bandgap and its application for the
low-pass filter design," in Proceedings of the Asia Pacific Microwave Conference (APMC '99), vol.
In the construction process of EMD or EEMD
low-pass filter, the order of the reconstructed signal is an important parameter of the filter and the selection of which is crucial to the denoising accuracy.
Toshiba's new electromagnetic induction transmitter IC integrates a full-bridge gate driver, a low-dropout (LDO) regulator with a 3.3V output and a
low-pass filter for recovery of an amplitude shift keyed (ASK) signal[3].