unannealed


Also found in: Thesaurus.

unannealed

(ˌʌnəˈniːld)
adj
1. (Ceramics) (of metal or glass) not annealed; not properly heated and cooled; brittle
2. (Metallurgy) (of metal or glass) not annealed; not properly heated and cooled; brittle
ThesaurusAntonymsRelated WordsSynonymsLegend:
Adj.1.unannealed - (of metal or glass) not annealed and consequently easily cracked or fractured
unhardened, untempered - not brought to a proper consistency or hardness; "untempered mortar"; "untempered steel"
Mentioned in ?
References in periodicals archive ?
Annealing at higher temperature of 80[degrees]C further enhanced yield strength to 38.3 MPa, corresponding to a 38% improvement from unannealed specimens.
The point is that this an easy part to injection mold, yet when tested under ASTM 256 test conditions there is a significant difference between an as-molded part (unannealed) and an annealed or nearly stress-free part.
Two cast films were prepared: one unannealed and the other annealed at 500[degrees]C by direct insertion in a furnace operated under atmospheric conditions.
The annealed samples are considered not to contain residual stress, so after the cutting, any form of deformation of the unannealed specimen relative to the corresponding position of the annealed specimen can be attributed to the release of residual stress.
An 8 x 10 x 2 mm corrosion test specimen was prepared from a unannealed specimen using a spark-erosion machine [7].
The best performance was obtained for the unannealed SnS film formed after two deposition cycles with an open-circuit voltage (Voc) of 0.3 V, short-circuit current density ([J.sub.sc]) of 0.373 mA/[cm.sup.2], fill factor of 31.7%, and efficiency of 0.04%.
The strength of fibers annealed without tension was lower than that of unannealed fibers.
On the contrary, solution annealing has no effect on the morphological properties of Y-branched PFO-DBT nanotubes as samilar morphological distribution between unannealed and annealed solution is observed.
There is a red shift for the films treated by thermal annealing only and thermal/laser coannealing compared to the unannealed film.
The main goal of this paper is to compare the NC effect in as-deposited (unannealed) nanocomposite samples with x [approximately equal to] 0.30 being on dielectric side IMT which contain oxidized CoFeZr nanoparticles embedded into dielectric matrixes--either [Al.sub.2][O.sub.3] or PZT.