undeformed

undeformed

(ˌʌndɪˈfɔːmd)
adj
well-formed
Mentioned in ?
References in classic literature ?
Slowly she descended the steps to the water, the temperature of which she tested with a symmetrical foot, undeformed by tight shoes and high heels--a lovely foot, as God intended that feet should be and seldom are.
Her figure was tall, yet not too tall; comely and well-developed, yet not fat; her head set on her shoulders with an easy, pliant firmness; her waist, perfection in the eyes of a man, for it occupied its natural place, it filled out its natural circle, it was visibly and delightfully undeformed by stays.
Fractured muds, mounds and undeformed muds are deep reserves with high volume, but extraction is costly.
The results indicated that grinding force of per grit, specific energy corresponding to the maximum undeformed chip thickness well.
The Limestone units of the Khyber Formation dominantly comprise of Calcite (CaCO3) with minor to trace concentration of dolomite, undeformed quartz and ores, classified as Algal laminated micritic mudstone.
But much of the roughness of Terra Laboris consists of ejecta from the formation of these two undeformed impact craters.
where [[alpha].sup.corr.sub.n] = k[DELTA][z.sup.broad.sub.n] are the terms that have the function of correcting the surface deformation and coincide with the phase shifts required by the PM to retrieve the pattern of the broadside array (they are given by the product between the wave vector k and [DELTA][d.sub.n] in Figure 3), while [mathematical expression not reproducible] is simply the phase shift that must be introduced into the nth element of the undeformed planar array in order to steer its main lobe into the desired direction.
In this study, a 5th order polynomial curve surface fitting algorithm (1) was applied for the generation of original 3-D surface on the basis of undeformed region, which proved its effectiveness and accuracy based on simulated volume removal and computational tests (maximum errors equal to 0.2 [mm.sup.3] and 1.1 [mm.sup.3], resp.) [11].
An energy method was used to predict the chip flow directions, and the calculated results agreed with the experimental results, which proved that the energy method is valid for designing appropriate undeformed chip geometry to reduce burrs in ultraprecision microgrooving on Ni-P plating [16].
The latter assumes that the cutting force is proportional to the undeformed chip cross section.